Tabla de contenido
Publicidad
STARTER MOTOR
$% 86.60.01
Remove
1. Disconnect battery earth lead.
1. Disconnect battery earth lead.
2. Remove engine compartment access panel
2. Remove engine compartment access panel
+
ENGINE COMPARTMENT ACCESS PANEL,
page 76-2-4.
3. Raise rear of vehicle.
3. Raise rear of vehicle.
WARNING: Support on safety stands.
4. Remove LH rear wheel.
4. Remove LH rear wheel.
5. Release EVAP canister from bracket and position
5. Release EVAP canister from bracket and position
canister aside.
6. Remove clip and disconnect air intake hose from
6. Remove clip and disconnect air intake hose from
throttle body.
7. Loosen clip and remove air intake hose from air filter.
7. Loosen clip and remove air intake hose from air filter.
8. Disconnect Lucar and release cable tie from starter
8. Disconnect Lucar and release cable tie from starter
motor solenoid.
9. Remove nut from solenoid and release 2 leads.
9. Remove nut from solenoid and release 2 leads.
10. Remove 2 nuts and bolts securing starter motor.
10. Remove 2 nuts and bolts securing starter motor.
11. Remove starter motor.
11. Remove starter motor.
ELECTRICAL
12. Remove flywheel closing plate.
12. Remove flywheel closing plate.
Refit
1. Clean mating faces of starter motor and gearbox.
1. Clean mating faces of starter motor and gearbox.
2. Fit starter motor.
2. Fit starter motor.
3. Fit closing plate.
3. Fit closing plate.
4. Fit nuts and bolts and tighten nuts to 80 Nm.
4. Fit nuts and bolts and tighten nuts to 80 Nm.
5. Fit leads to starter solenoid and tighten terminal nut.
5. Fit leads to starter solenoid and tighten terminal nut.
6. Connect Lucar to starter solenoid.
6. Connect Lucar to starter solenoid.
7. Secure cables to starter solenoid with cable tie.
7. Secure cables to starter solenoid with cable tie.
8. Fit air intake hose to air filter and to throttle body.
8. Fit air intake hose to air filter and to throttle body.
9. Tighten clip securing air intake hose to air filter, fit clip
9. Tighten clip securing air intake hose to air filter, fit clip
securing air intake hose to throttle body.
10. Fit EVAP canister.
10. Fit EVAP canister.
11. Fit road wheel(s), fit wheel nuts and tighten in a
11. Fit road wheel(s), fit wheel nuts and tighten in a
diagonal sequence to 70 Nm.
12. Remove stand(s) and lower vehicle.
12. Remove stand(s) and lower vehicle.
13. Fit engine compartment access panel.
13. Fit engine compartment access panel.
+
ENGINE COMPARTMENT ACCESS PANEL,
page 76-2-4.
14. Connect battery earth lead.
14. Connect battery earth lead.
86-23
REPAIRS
Publicidad
Tabla de contenido
