Tabla de contenido
Publicidad
ENGINE COOLANT TEMPERATURE GAUGE
SENSOR
$% 88.25.20
Remove
1. Disconnect battery earth lead.
1. Disconnect battery earth lead.
2. Remove engine cover.
2. Remove engine cover.
+
ENGINE COVER, page 12-27.
3. Disconnect multiplug from sensor.
3. Disconnect multiplug from sensor.
4. Position a container below sensor to collect coolant
4. Position a container below sensor to collect coolant
spillage
5. Remove sensor.
5. Remove sensor.
Refit
1. Clean threads of sensor.
1. Clean threads of sensor.
2. Apply Loctite 577 to threads of sensor.
2. Apply Loctite 577 to threads of sensor.
3. Fit sensor and tighten to 6 Nm.
3. Fit sensor and tighten to 6 Nm.
4. Connect multiplug to sensor.
4. Connect multiplug to sensor.
5. Fit engine cover.
5. Fit engine cover.
+
ENGINE COVER, page 12-27.
6. Connect battery earth lead.
6. Connect battery earth lead.
7. Top-up coolant.
7. Top-up coolant.
+
DRAIN AND REFILL, page 26-1.
INSTRUMENTS
ENGINE OIL TEMPERATURE GAUGE SENSOR
$% 88.25.21
Remove
1. Raise rear of vehicle.
1. Raise rear of vehicle.
WARNING: Support on safety stands.
2. Disconnect multiplug from sensor.
2. Disconnect multiplug from sensor.
3. Position spillage tray.
3. Position spillage tray.
4. Remove sensor from oil filter housing.
4. Remove sensor from oil filter housing.
Refit
1. Fit oil temperature sensor to oil filter housing and
1. Fit oil temperature sensor to oil filter housing and
tighten to 15 Nm.
2. Remove spillage tray.
2. Remove spillage tray.
3. Connect multiplug to sensor.
3. Connect multiplug to sensor.
4. Remove stand(s) and lower vehicle.
4. Remove stand(s) and lower vehicle.
5. Check and top up engine oil level.
5. Check and top up engine oil level.
+
ENGINE OIL, page 10-3.
88-3
REPAIRS
Publicidad
Tabla de contenido
