Installation; Mounting The Appliance; Application; Mounting - Stiebel Eltron DHC-E 8/10 Guía De Operación E Instalación

INSTALLATION

MOUNTING THE APPLIANCE

INSTALLATION
5. Mounting the appliance
5.1

Application

One appliance can be used for the following applications:
one or multiple hand washing sinks
one kitchen sink
cabins with fl ow restriction at shower head.
A combination of two appliance can be used for whole apartment
and house applications. Please contact STIEBEL ELTRON for special
installation instructions.
All areas with a ground water temperature likely to exceed 65 °F
(18 °C) year round:
Whole apartment or house
CAUTION Electrocution
Unit must be installed in a vertical position with the
water fi ttings pointing downward. In this position the
unit is splashproof, so that no water can soak in.
1
7
2
1
3
4
7
5
6
1 Hot valve (left)
2 Cold valve (right)
3 Sink
4 1/2" main pipe
5 Water supply line for faucet installation
6 Shut-off valve
7 Electrical junction box
5.2

Mounting

 Install appliance as close as possible to the main hot water
draw-off points.
 Install appliance in a frost free area. If frost may occur, re-
move appliance before freezing temperatures set in.
 Leave a minimum of 5" of clearance on all sides for servicing.
WWW.STIEBEL-ELTRON.COM
2
3
4
5
6
 Remove plastic cover.
 Screw the screws into the wall and hang the appliance.
Screws and plastic wall anchors for mounting on masonry or
wood are provided.
 Secure the screws.
5.3

Water connections

!
Damage to the appliance and the environment
Excessive heat from soldering on copper pipes near the
DHC may cause damage.
DHC-E | 5