Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY
TO INSTALL THE UPPER HANDLE
AND CRANK ASSEMBLY
•
Loosen, but do not remove, the screws, flatwashers,
lockwashers, and hex nuts in the upper holes of the
lower handle (See FIG. 4).
•
Raise upper handle into operating position. Upper
handle should be to the outside of the lower handle.
•
Using the
hardware
(screws,
flatwashers,
lockwashers,
and hex nuts found in parts bag)
attach the upper and lower handle inthe lowerholes.
Do nottighten untilall screws are in place (See FIG,
4).
•
Tighten four handle bolts.
•
Install push caps on end of screws.
•
Remove the 3/8" nylon Iocknut and flatwasher from
the eye bolt assembly (on the chute crank assem-
bly removed earlier) (See FIG. 4A).
•
Install eye bolt through lower hole in the Ietthand side
of the handle (See FIG. 4A).
•
Install the 3/8" flatwasher and the 3/8" nylon Iocknut
loosely on the eye bolt as shown in FIG. 4A
•
Carefully remove cotter pin, clevis pin and drilled pin
from yoke end of crank rod assembly (See FIG. 5).
•
Place universal joint into end of worm gear lining up
large holes. Insert universal pin (ensure opening in
pen is in line with small openings in universal
joint) (See FIG. 5).
•
Place yoke end of crank rod around universal joint,
lining up openings. Insert clevis pin through assem-
bly and secure with cotter pin. Spread ends of cotter
pin to lock in place (See FIG. 5).
•
Tighten nut on eye bolt securely.
NOTE: Make sure the cable is not caught between the
upper and lower handle. Also make sure the cable is not
wrapped or tangled around handles.
5!16 INCH HEX NUT/
/
5116 INCH LOCKWASHE$
FIG. 4
LOOSEN, BUTDO
NOT REMOVE
/
5/16 INCH
FLATWASHER
'/_5tl
6 X 2 INCH
SCREW
UPPER
HANDLE "_
f
/,f
3t8 INCH NYLON
LOCKNUT
318 INCH
FIG. 4A
CLEVIS PiN
PIN
UNIVERSAL JOINT
CRANK ROD
ASSEMBLY
UNIVERSAL PIN
FIG. 5
8
Publicidad
