Remote Oil Hook-Up; Start-Up Instruction - L.B.White Foreman CI230 Manual Del Usuario E Instrucciones

Remote Oil Hook-Up

CI750 model will ship for connection to an
external fuel tank
• For CI230 and CI500, kit 500-131261 must be installed for
connection to an external tank.
Connecting to a remote fuel tank.
Materials
• Tefl on tape (use on all threaded connections)
• Appropriate pipe fi ttings to adapt to the 3/8 in. NPT female
threads of the fuel fi lter's inlet if tank connection differs
Tools
• 11/16 in. open end wrench
• Adjustable wrench
Drawing fuel from an external bulk tank
• The fuel supply hose from the bulk tank must be the same
diameter as the fi tting on the remote tank.
• Use appropriate pipe fi ttings to reduce to the 3/8 in. NPT
threads on the fuel fi lter.
• Check ALL connections for tightness.
• Start the heater and check all connections for leaks.
Retighten as necessary to stop any fuel leaks.
Using the onboard fuel tank
• Model CI230 & CI500 ship ready to operate from the
onboard tank
• The CI750 requires hook-up from the onboard tank to the
fuel fi lter.
- Remove the blue cap from the hose at the onboard tank.
(See hose fi gure above.)
- The connection hose supplied has a 3/8 NPT so it can
connect directly to the fuel fi lter's inlet.
Foreman Ductable Oil Indirect-Fired Heater
Start-Up Instructions
For initial start-up after heater installation, follow steps
1-5. For normal start-up, set the thermostat above room
temperature or set thermostat selector switch to the
manual position.
1. Follow all ventilation and safety information.
2. Fill tank with fuel.
3. This heater is wired with a ground connection for
4. Set thermostat to desired room temperature or set
5. This heater has a rocker style selector switch
6. When the switch is set to heat
7. Do not exceed input rating stamped on nameplate
Owner's Manual • Foreman
- Check ALL connections for tightness.
- Start the heater and check all connections for leaks.
Retighten as necessary to stop any fuel leaks.
- When switched back to the external tank ensure
blue cap is securely installed to protect the hose's
threads.
your protection against electrical shock hazard. The
heater must be connected directly to a properly wired
and grounded electrical supply. Minimum breaker
size: CI230-15 amp, CI500/CI750-20 amp.
thermostat selector switch to the manual position.
located on the side of the heater. This switch
allows for either heat mode or ventilate mode
(no heat).
lights will be activated in sequence as specifi c circuits
are checked by the heater controller. If the heater
does not light, and a status light is off, refer to the
trouble shooting section of this manual.
or manufacturer's recommended pump pressure for
nozzle used. Make certain that the primary air supply
to main burner is open and free of dust, dirt and
debris for complete, proper combustion.
13
, three status