Safety System - L.B.White Foreman CI230 Manual Del Usuario E Instrucciones

e. At no time shall more than one day's supply of
heater fuel be stored inside a building in the
vicinity of the heater. Bulk fuel storage shall
be outside the structure.
f. All fuel storage shall be located a minimum of
25 feet (7.62m) from heaters, torches, welding
equipment, and similar sources of ignition
(exception: the fuel reservoir integral with the
heater unit).
g. Whenever possible, fuel storage shall be
confi ned to areas where fl oor penetrations do
not permit fuel to drip onto or be ignited by a
fi re at lower elevation.
h. Fuel storage shall be in accordance with the
authority having jurisdiction.
i. Fuel storage shall not be permitted within 10 ft.
(3.05 m) of fl oor penetrations used for vertical
access unless separated from the penetration
by full masonry height walls.
15. Use only in areas free of fl ammable vapors or
high dust content.
16. Locate heater on a stable and level surface while
hot or operating. Use a level.
17. Never start heater if fuel has accumulated in
combustion chamber.
18. Heater may start at any time when used with
thermostat.
19. When heater is stored, it must be in a level
position.
20. Never move, handle, refuel, or service a hot,
operating, or plugged-in heater.
21. Follow all local codes if connecting the heater to
an external fuel source.
22. Heaters used in the vicinity of tarpaulins, canvas,
or similar enclosure materials shall be located
in safe distance from such materials. The
recommended minimum safe distance is 10 ft.
(3.05 m). It is further recommended that these
enclosure materials be of a fi re retardant nature.
These enclosure materials shall be securely
fastened to prevent them from igniting or from
upsetting the heater due to wind action.
Foreman Ductable Oil Indirect-Fired Heater
23. Unplug heater when not in use.
24. When the heater is used in an enclosed or par-

Safety System

High Temperature Control: The heater is
equipped with a high temperature switch designed to
turn the heater off if the internal temperature reaches
an unsafe level.
CAD Cell: A light senative resistor. Used to sense
the presence of light in the heat exchanger, allowing
the heater to continue its operation.
CAD cell fl ame detection range
Normal condition = 0 to 1600 ohms
Owner's Manual • Foreman
tially enclosed permanent or temporary structure,
tests for the presence of carbon monoxide shall
be made within one hour after the start of each
shift, and at least four hours thereafter. Immedi-
ate, more frequent testing may be dictated by job
conditions.
7