Declaration Of Conformity - Emerson FB2200 Instrucciones Para Un Uso Seguro

Emerson FB2200 Flow Computer
Figure 1. Emerson FB2200 Label
(Non-sparking with Integral Sensor)
Use this safe use instructions (SUI) document with the
Emerson FB2200 Flow Computer Instruction Manual (part
D301784X012). For full cautions and descriptions of
installation and troubleshooting procedures, refer to this
manual. If you require training for this product, contact
your local sales office.
The Emerson FB2200 Flow Computer (or "FB2200") with
ATEX approval may be ordered with any of the optional
communications or I/O modules listed in the product data
sheet Emerson FB2200 Flow Computer (part
D301792X012).
Figure 2. Emerson FB2200 Label
(Non-sparking without Integral Sensor)

Declaration of Conformity

Hereby, Remote Automation Solutions declares that the
Emerson FB2200 Flow Computers are in compliance with
the essential requirements and other relevant provisions
of European Directives 2014/30/EU (EMC), and
2014/34/EU (ATEX).
Remote Automation Solutions
Safe Use Instructions – Emerson FB2200
Specific Conditions of Use
Use equipment in an area of not more than pollution
▪
degree 2.
Make provisions to ensure, in the event of transient
▪
disturbances, that the rated voltage does not exceed
140% of the peak rated voltage.
Lead acid battery and solar power options are not for
▪
use in ATEX applications.
Impact tests on the display were conducted based on
▪
Group II values for the low risk of mechanical danger,
in accordance with Table 13 of both EN 60079-
0:2012+A11:2013 and IEC 60079‐0 6
flow computers with displays in areas where the risk of
impact is low.
In Zone 2 installations, ensure that the flow computer
▪
is installed and used to prevent the danger of
electrostatic charges.
The FB2200 enclosure requires a tool to open. Refer to
▪
the Physical Security section in Chapter 1 of the
Emerson FB2200 Flow Computer Instruction Manual
(part D301784X012) for further details.
Table 1 for replacement parts.
▪
Table 1. Replacement Parts
Replacement Part Kit Number
8-Channel Expansion
400217010-KIT
I/O Board
6-Channel Expansion
400215010-KIT
I/O Board
HMI Module Display 399379-01-0,
621627011-KIT,
Assembly
399380-01-0,
621627020-KIT
400210010-KIT,
I/O Termination
Board 358807010-KIT
CPU Enclosure and 621673-01-0,
621674-01-0,
Electronics
621675-01-0,
621676-01-0,
621678-01-0,
400209010-KIT,
399260-01-0,
399264-01-0,
400211010-KIT
Sensor Variable Kit Number
399291-01-0,
Door Accessories
399267-01-0,
399266-01-0,
621661010-KIT,
399394-00-0
395828-01-0
Relay
395620-03-1
Coin Cell Battery
Part D301801X012
September 2018
th Edition. Install
Field Replacement
Guide document
number
D301804X012
D301803X012
D301822X012
D301805X012
D301803X012
D301843X012
D301825X012
D301847X012
D301855X012