NIOSH RPB T-LINK Manual De Instrucciones página 12

SETUP AND USE
ATTACHING THE BREATHING TUBE
FIGURE 3.1
Line up the hole in the inlet seal with the inlet
hole in the back of the helmet.
POWERED AIR
Insert the bayonet end of the breathing tube
into the outlet of the PX4 AIR
twist it in until it is secure.
12
CONTINUED
FIGURE 3.3
PAPR and
®
FIGURE 3.2
Insert the externally threaded end of the
breathing tube into the inlet hole and tighten
the breathing tube into the inlet until tight
making sure not to twist the hood as it gets
tight.
FOR USE WITH RPB
PAPR USER MANUAL
When the T-LINK Respirator is being used in
®
conjunction with the RPB
please refer to the RPB
Instruction Manual for set up and use of the
assembly.
Note: The RPB
PX4 is a Powered Air
®
Purifying Respirator, therefore care must be
taken when selecting the correct filter for the
application the respirator will be used in.
PX4 AIR - SEE THE
®
PX4 AIR PAPR,
® ®
PX4 PAPR User
®