Assembly Instructions - Troy-Bilt TBBV Manual Del Operador

NOTE: Your unit is completely assembled as a blower in
the carton. Use the following instructions to
convert between a blower and a vacuum.
WARNING: To avoid serious personal injury
and damage to the unit, shut unit off before
removing or installing add-ons.
CONVERTING TO A VACUUM
1. Loosen the clamping knob on the blower housing
counterclockwise.
2. Remove the blower tube.
3. Install the bag elbow and tighten the knob clockwise
(Fig. 1).
Knob
4. Fasten the strap to the shaft above the assist handle,
located on the powerhead (Fig. 2).
Strap
Shaft

ASSEMBLY INSTRUCTIONS

Elbow
Vacuum Bag
Fig. 1
Assist Handle
Fig. 2
CONVERTING TO A BLOWER
1. Remove the vacuum bag.
2. Clip the blower tube to the end of the vacuum tube
(Fig. 3).
3. Install the blower tube and tighten the knob (Fig. 4).
Knob
Blower Tube
Vacuum Tube
Clip
Blower Tube
Fig. 3
Fig. 4
7