Brizo MultiChoice 60 Serie El Manual Del Propietario página 4

60 Series Installation
Showerhead and Tub Spout Installation
2
(For Tub Spout installation refer to the installation guide provided with your tub spout)
FOR SHOWERHEAD INSTALLATION:
top outlet (1) to shower arm (2) with proper fittings.
To prevent damage to finish on shower arm,
insert wall end of shower arm into shower flange
(3) before screwing arm into riser connection.
Thread showerhead (4) onto shower arm. Apply
plumber tape to pipe threads on both ends. Do not
overtighten showerhead.
Valve Trim Installation
3
(See page 6
A.
1
Slide O-ring (1) over cartridge and the bonnet
nut (2). The O-ring, which acts as a spacer to
steady the sleeve, should rest behind the
bonnet nut.
84528 Rev. C
3
2
4
& 7 for Siderna
2
1
FOR RSVP® SOTRIA® AND VIRAGE®
Connect
SHOWERHEAD AND SHOWER ARM
INSTALLATION:
extend beyond the finished wall 3/8" to 1/2". Apply
plumber tape to thread on pipe nipple and screw
brass adapter (1) securely onto nipple. Apply plumber
tape to outlet end of shower arm and screw
showerhead (2) onto the shower arm (3), using
provided wrench (4) to tighten securely. Check
position of set screw on top of shower arm (3) making
sure it is not sticking through to the inside opening
where it could interfere with the assembly. Slide
shower arm and head assembly over the adapter and
tighten set screw against the adapter.
valve trim installation.)
®
B.
2
If your model requires a spacer (1), install it into
sleeve (2). Slide the sleeve over the cartridge, body
and O-ring. Ensure sleeve is properly positioned
over the front of cartridge. Note: RSVP
(series T60X90) do not require spacer (1).
4
3
1
4
2
Install a 1/2" threaded pipe nipple to
1
models
®