Description; Introduction; Packing List; Optional Accessories - AKG SR 4500 Modo De Empleo

2.1 Introduction

2.2 Packing List

2.3 Optional Accessories

2.4 General Description

2.5 Controls

2.5.1 Front Panel

Refer to fig. 1.
18

2 Description

Thank you for purchasing an AKG product. This Manual contains important instructions for setting up and operating your
equipment. Please take a few minutes to read the instructions below carefully before operating the equipment.
Please keep the Manual for future reference. Have fun and impress your audience!
1 SR 4500 receiver
• Check that the packaging contains all of the components listed above. Should any item be missing, please contact
your AKG dealer.
• For optional accessories, refer to the current AKG catalog or folder, or visit www.akg.com. Your dealer will be glad
to help.
The SR 4500 is a stationary True Diversity receiver for use with all WMS 4000 transmitters. The SR 4500 operates in
a subband up to 30 MHz wide of the 500 MHz to 862 MHz UHF carrier frequency band. Within the subband, you can
either set the carrier frequency directly in 25-kHz increments or select one of the channels of the Preset Frequency
Groups of your receiver.
A backlit display indicates all important parameters including the receiving frequency, audio level, RF level, current op-
erating mode, and remaining transmitter battery life.
The receiver provides two operating modes:
• In LOCK mode, all setup functions are electronically locked to prevent parameters from being readjusted uninten-
tionally during a performance or lecture. The "LOCK" label on the display indicates the receiver is in LOCK mode.
• ACTIVE mode allows you to adjust and save all receiver parameters. In ACTIVE mode, the "LOCK" label disappears.
The receiver provides both a balanced XLR and an unbalanced 1/4" audio output.
You can use the receiver as a standalone unit or install it in a 19" rack using the supplied rack mounting kit.
1 ON/OFF: Switches power to the unit on or off.
2 Display: The receiver provides a backlit display:
The display indicates all receiver parameters:
a e
a Audio level
b Preset/Receiver Name, Frequency Group, Channel (shown in Preset and NAME screens only)
c Received signal field strength
d Diversity indicators (A/B)
e Alphanumeric display of current setting or transmitter battery capacity
f Parameter to be adjusted, mode
3 SETUP: Sets the various parameters of the receiver. The SETUP control has the following functions:
• Long push: Toggle between LOCK and ACTIVE modes.
• In LOCK mode:
- Turn all the way CW or CCW to scroll through the Preset screen (only available if a Preset has been stored pre-
ciously), Frequency screen, receiver name, battery status (battery capacity in hours), and Gain displays.
• In ACTIVE mode only:
- Short push: Call up the selected menu or confirms a selected value.
2 UHF antennas 1 19" rack mounting kit
f
c d
SR 4500