Unhooking The Seed Drill From The Tractor - GASPARDO ORIETTA OLIMPIA Instrucciones De Uso

2) Connect the third upper point (2, Fig. 8); the pin will be
blocked with the appropriate split pin; use the adjusting
tierod (3, Fig. 8) to keep the seeder perpendicular to the
ground (Fig. 9).
3) Block the movement of the parallels of the tractor on the
horizontal plane using the stabilizers provided, so
eliminating the side swaying of the equipment. Check that
the tractor hoisting arms are positioned at the same height
from the ground.
4) Adjust the height of the tractor lifting arms:
a) In the work position, adjust the path of the tractor hoisting
arms to guarantee adequate downward movement of the
planting unit. Otherwise, when hollows are encountered
in the seedbed, seed distribution could be irregular due
to the seed planting unit transmission wheels slipping
(planing effect).
b) in the transporting position, adjust the arms so that the
seeder does not, for any reason whatsoever, come into
contact with the ground.
5) The hydraulic pipes must be connected correctly to the tractor
distributors following the instructions on each pipe (Fig. 10).
6) Connect the Cardan shaft and make sure that it is perfectly
blocked on the power take-off. Check that the guard turns
freely and fix it with the chain provided.
During the work, regularly check that the equipment is
perpendicular.
ATTENTION
For transportation of the seeder, always follow the
Manufacturer's instructions.

3.2 UNHOOKING THE SEED DRILL FROM THE TRACTOR

Unhooking the seed drill from the tractor is a very dangerous
operation. Great caution must be used and the whole operation
must be carried out following the instructions.
For a correct unhooking operation of the seed drill it is necessary
to proceed on a horizontal level.
1)Lower the supporting base elements
2)Slowly lower the seed drill until it rests completely on the
ground.
3)Disconnect the hydraulic pipes from the tractor distributors and
protect the quick couplings with the caps.
4)Unhook the Cardan shaft from the tractor and put it on the
special hook.
5)Loosen and unhook the third point, following the first and
second.
cod. G19502812
DANGER
USE AND MAINTENANCE
g
ENGLISH
fig. 8
2
3
fig. 9
fig. 10
51