Leggett & Platt Simplicity 3.0 Manual De Instrucciones página 6

SteP 2
Uncoil the main power cord and extend it out head
end of base, then remove the hardware box from
shipping container. Cut the zip-tie and remove the
mattress retainer.
SteP 3
Install (4) legs into the base frame. Simply screw each
leg into a tapped hole at each corner of the base frame
(FIGURE 1).
FIGURE 1
LEGS – SCREW INTO
SteP 4
With base still in shipping carton, rotate the entire bottom carton on
its edge and then gently rotate over so base is resting on its legs.
READ ALL INSTRUCTIONS BEFORE USING
WARNING WARNING
DUE TO RISk OF INjURY, TWO PEOPLE
ARE REqUIRED TO HANDLE AND MOvE
ADjUSTABLE BASE.
6
S-cape 2.0 / S-cape + 2.0 / Simplicity™ 3.0 Owners Manual 290-0010-c
® ®
TAPPED HOLE AT
EACH CORNER
PUSH PIN IN
TO ADjUST LEG
HEIGHT
(6 INCHES TO
10 INCHES)
iNStallatioN
READ ALL INSTRUCTIONS BEFORE USING
POWER CORDS MUST NOT INTERFERE
DO NOT WEAvE CORDS THROUGH BASE
WARNING WARNING
WITH ANY ADjUSTABLE BASE
MECHANISMS.
STRUCTURE.