Tasco Snap Shot Manual Del Usuario página 6

12. To enter "Low Resolution" mode, which will cause your
pictures to be of a lower resolution, but will also allow you
to store many more pictures in the camera's memory, press the
MODE button 3 times until you see the "LQ" icon blinking.
P ress the S N A P button to select this mode. The "Low" icon
will then stop blinking. Entering this mode later and pre s s i n g
S N A P again will re t u rn you to "High Resolution" mode.
13. When in "Normal" mode press the MODE button 4 times to enter the "AVI"
mode. The " " icon will begin to blink. Press the S N A P button to select this
mode. The " " will then stop blinking. Holding down the S N A P button will
take AVI clips as long as you continue to depress the button or until the memory is
full. Once you release the button the camera will revert back to "Normal" mode so
you can take still (i.e. non-action) pictures again as long as there is unused memory
left. Repeat step 11 if you want to change the camera to the AVI mode again.
14. You can chose between the 50mhz and 60mhz settings for the camera output. The
camera's default mode is the "60" mode, which matches the power frequency for
the United States. To change to the "50" mode, press the S N A P button until the
"60" changes to "50." Confirm the selection by pressing the S N A P button. To
avoid any flickering on the picture, the correct power frequency (either 50 or 60)
for your country must be selected.
10
15. If "Delete Last" mode is selected, the display will show the following:
LQ
Press SNAP to delete the last picture from the camera's memory.
16. If "Delete All" mode is selected, the word "ALL" appears next to the icon on the
display. To delete all pictures in the camera's memory, select this mode. The picture
number will then blink. Press and hold the SNAP button. You will hear a tone
that becomes higher as the pictures are deleted. Once complete, the picture
number will reset to zero. If no button is pressed for a while, the camera returns
to stand-by.
17. If the "Battery" indicator is only one third highlighted, it is necessary to replace the
batteries soon.
11