Aqua Medic spectrus 60 Manual De Instrucciones página 16

Mounting:
The two ceiling mountings (2) must be securely screwed to the ceiling by using the screws and
plugs. Suitable screws and plugs are provided but you should ensure your ceiling is capable of
holding the weight of the light in this way.
Stainless steel cable:
The stainless steel cable is now fed through the cap (5) of the ceiling mounting so that the stopper
(4) is retained inside. The retaining bush is screwed onto the ceiling mounting allowing the
stainless steel cable to hang free.
Fixing the light:
The stainless steel cable (6) has to be drawn through the stainless steel cable holder (7). To do so,
the cable is fed through the fixing from the top (2.1.1). It is drawn through the side opening
(2.1.2) and then it has to be pulled until the light is in the correct height above the aquarium. As
soon as the light is adjusted in the right position, tighten the safety bolt (8) to avoid a canting of
the light.
Release the fixing:
The light fixing has a non-return mechanism so that the cable can easily be adjusted. To remove
the light or re-adjust the height, press the adjustment screw (2.1.1). – Caution: Hold the light
tight! Now, the stainless steel cable can be pulled out of the light fixing.
When the light is mounted in the correct position, any surplus cable may be cut off by pliers.
Pay attention to a sufficient distance to the water surface so that no water splashes can
reach the light.
In course of time, even stainless steel can corrode by humid ambient air. Therefore,
check the steel cables regularly and replace them, if necessary.
16