Connections To Be Made; From The 16-Pin Harness; From The 22-Way Harness - Axxess FRST-2 Instrucciones De Instalación

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Connections to be made

1. From the 16-pin harness:

Connect the Red wires to the ignition/accessory wire of the aftermarket radio.
Connect the Orange/White wire to the illumination wire of the aftermarket radio.
If the aftermarket radio has no illumination wire, tape off the Orange/White wire.
Connect the Blue/White wire to the amp turn on wire of the aftermarket radio.
Connect the Brown wire to the mute wire of the aftermarket radio.
If the aftermarket radio does not have a Mute wire, tape up the Brown wire.
Connect the White wire to the left front positive speaker output of the aftermarket radio.
Connect the White/Black wire to the left front negative speaker output of the
aftermarket radio.
Connect the Gray wire to the right front positive speaker output of the aftermarket radio.
Connect the Gray/Black wire to the right front negative speaker output of the
aftermarket radio.
The Violet wire is not used in the application.
The Violet/Black wire is not used in the application.
The Green wire is not used in the application.
The Green/Black wire is not used in the application.
The following wires are for the aftermarket radios that have navigation built in:
Connect the Light Green wire to the parking brake wire of the aftermarket
navigation radio.
Connect the Blue/Pink wire to the VSS or speed sense wire of the aftermarket
navigation radio.
Connect the Green/Purple wire to the reverse wire of the aftermarket navigation radio.

2. From the 22-way harness:

Connect the 3.5mm jack to the aftermarket radio's steering wheel control (SWC) input
(if equipped). Note: If using Eclipse, Kenwood, or select JVC radios use the supplied
female 3.5mm adaptor.
Continued on next page
FRST-2
4

Publicidad

Capítulos

Tabla de contenido
loading

Este manual también es adecuado para:

Frst

Tabla de contenido