Scooter Settings - e-TWOW S2 BOOSTER Instrucciones De Uso

Solution: Turn off the power then restart again, if the problem still occurs,
please contact your local reseller.
4. The rear electric brake does not work
Reason: The rear brake sensor is defective, or the electrical wiring is
interrupted.
Solution: Visually check the integrity of the sensor and electrical cables
(they are located near the rear shock absorber)
In case that the product still does not operate normally, please contact your
local vendor or reseller.
For E-TWOW scooters manufactured before 01.06.2017, please use the setting below.
The cruise control function can be activated/deactivated following the instructions
below:
¾ Turn off the scooter;
¾ Press the brake handle all the way down and with the brake handle pressed
like this turn on the scooter;
¾ Do not release the brake handle;
¾ With the brake handle still pressed all the way through, please press the
acceleration handle all the way down 2 times;
¾ Release both handles;
¾ Now the cruise control is activated;
¾ To deactivate it please follow the same steps as above.
Using the same procedure as before, there are more functions you can use if
you press the acceleration handle (step 4) as follows:
- if you press the acceleration handle 2 times --> activate/ deactivate the cruise
control function
- if you press the acceleration handle 3 times --> activate/ deactivate the kick
start function
- if you press the acceleration handle 4 times --> deactivate the speed limit
function
- if you press the acceleration handle 5 times --> activate a maximum speed limit
of 25 km/h
- if you press the acceleration handle 6 times --> activate a maximum speed limit
of 20 km/h
- if you press the acceleration handle 7 times --> activate a maximum speed limit
of 6 km/h
- if you press the acceleration handle 8 times --> activate a maximum speed limit
of 12 km/h

SCOOTER SETTINGS

13
ELECTRIC TWO WHEELS
A NEW ERA IN URBAN MOBILITY