Publicidad
Installation Instructions
TRAY INSTALLATION
1.
Reinstall ceiling tile with extension column hole. Ensure tile
is oriented for proper location of hole.
2.
Reinstall tray (A) on top of ceiling tile so that extension
column support is centered over hole in tile.
3.
Position tray (A) with four screws (G) as required:
•
For 24" (610mm) Framework: Install screws through
end bracket inside holes (See Figure 7).
•
For 600mm (23-5/8") Framework: Install screws
through end bracket outside holes (See Figure 8).
24" (610mm)
Figure 7
600mm (23-5/8")
Figure 8
3
(G) x4
A
3
(G) x4
3
A
CAUTION:
Failure to properly tension cables (C) may
result in damage to ceiling tile framework!
4.
Thread each cable (C) completely through cable lock (F),
corresponding hole in corner of tray (A), and completely
through opposite side of cable lock (F) (See Figure 9).
Adjust cable tension until tray (A) is supported entirely and
evenly by all four support cables, but not so tight as to distort
ceiling tile framework.
NOTE:
Cable lock (F) will allow cable to enter from only one
direction per side, indicated by arrows on lock.
Depress spring loaded pins on cable lock (F) to release
cable tension.
C
4
F
Figure 9
CMS440
A
(C, F) x4
9
Publicidad
