Troubleshooting - GreenWorks 2600202 El Manual Del Propietario

TROUBLESHOOTinG

PROBLEM
Then handle is not
in position.
The Snow Thrower
does not start.
The motor is on, but The belt is damaged.
the impeller does
not turn.
The snow thrower
leaves a thin layer of
snow behind.
POSSIBLE cAUSE
The bolts are not properly
seated.
The switch is defective.
The extension cord is not
connected to the plug.
The extension cord is not
connected to the power source. AC, 60 Hz outlet.
The scraper is worn.
SOLUTION
Make sure the bolts are correctly installed
through the handle bars. Check to see if
the hand knobs are tight.
Refer to Assembling the Handle section in
this manual.
Have the switch replaced by an authorized
service center.
Connect the plug on the snow thrower to
the extension cord.
Plug the extension cord into a live 120 V
Replace the belt (see the section entitled
inspecting/Replacing the Drive Belt).
inspect the scraper for wear or damage.
Replace the scraper (see the section
entitled Replacing the Scraper).
25