Cleaning Your Machine - Bissell PROHEAT 2X LIFT-OFF Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

C-3 Area rug cleaning
Important! Please check manufacturer's tag
before cleaning area rugs for any specialized
cleaning instructions. We do not recommend
deep cleaning delicate, silk, wool, antique or
area rugs without a manufacturer's tag.
When cleaning area rugs, place the rug on a
sealed surface and test a small, inconspicuous
area for colorfastness. Your carpet cleaner
should not be used on unsealed surfaces.
Follow carpet cleaning instruction in section
C-2. Keep the foot of the cleaner perpendic-
ular to the rug's edge with each cleaning pass
to prevent damage.
C-4 Empty dirty tank
1. When dirty tank reaches "FULL" line on
tank, it is time to empty.
2. Remove dirty tank and carry to a utility
sink, toilet or outside (where you will dispose
of the dirty water).
3. To unlock dirty tank lid, rotate handle
over back of tank. Remove lid and pour out
dirty water. Rinse out dirty tank to remove
any debris.
4. Replace top of tank, and rotate handle
forward to lock in place on front of tank.
5. Before replacing tank on machine, wipe
debris from red filter.
8
www.BISSELL.com
C-5 Cleaning your machine
1. Flush out machine of any remaining
residual solution.
a. Fill formula & water tank with hand
hot (60°C/140°F MAX) tap water and
turn on machine.
b. Recline handle and press spray
trigger for about 15 seconds while
making forward and backward
passes on carpet. Continue without
pressing spray trigger until there is
no more water being suctioned up.
c. Turn off machine and wrap power
cable. Make sure dirty tank and the
formula & water tank are emptied,
rinsed, and dried before next use.
d. Before you replace tank, clean all
debris from red filter screen.
2. Rinse nozzle assembly of any dirt
and debris.
a. Remove portable spot cleaner from
base of the machine.
b. Remove nozzle assembly from
machine by unscrewing 3 screws and
lifting away upper and lower nozzle.
c. Rinse upper and lower nozzles in
clean tap water.
d. Place lower nozzle back onto machine
by hooking tabs into holes on bottom
sides of front of machine.
e. Place upper nozzle onto lower nozzle
by hooking tabs into the holes on front
of lower nozzle. Secure with 3 screws.
3. Inside of end caps can be wiped out
with a clean paper towel, or for a more
thorough clean, end caps can be taken
off and rinsed clean.
4. Any loose hair or debris can be pulled
from brush rolls and thrown away. For a
more thorough clean, follow directions
in section D-4 for removal of brush rolls.
Machine is now ready to be stored.
NOTE: Store cleaner in a protected, dry
area. Since product uses water, it must
not be stored where there is a danger of
freezing. Freezing will damage internal
components and void the guarantee.

Publicidad

Tabla de contenido
loading

Tabla de contenido