Controls A Nd Features; Chokecontrol - Troy-Bilt Storm 2620 Manual Del Operador

Controls a nd Features
4
F
Chute Assembly
'2
\\
Drive Control
Clean Out
Tool _
Augers
Gas Cap
\
\
OU FUl
\
\
Skid Shoe
Shift Lever
J Chute Directional Control
Auger Control
Primer
Muffler Recoil Starter
\ Handle
\
\
ignition
Key
Throttle
Control
Choke
Control
Oil Drain
Electric Start
Button
Electric Starter Outlet
'_h J
Figure 4-1
Snow thrower controls and features are described below and
illustrated in Fig. 4-1.
Shift Lever 6
The shift lever is located in the right side of the 5
handle panel and is used to determine ground
speed and direction of travel. 4
Forward 3
There are six forward (F) speeds. Position one (1) is
the slowest and position six (6) is the fastest, t 2
Reverse F 1
There are two reverse (R) speeds. One (1) is the
slower and two (2) is the faster.
R1
ChokeControl
The choke control is found on the rear of
the engine and is activated by rotating
the knob clockwise. Activating the choke
control closes the choke plate on the
carburetor and aids in starting the engine.
Ignition Key
The ignition key is a safety device. It must
be fully inserted in order for the engine to
start. Remove the ignition key when the
snow thrower is not in use.
Note: Do not turn the ignition key in an
attempt to start the engine. Doing so may
cause it to break.
R2
11