ANSMANN POWERBANK 12.8 Manual Del Usuario página 6

USE
CAPACITY DISPLAY
Press the power button to check the energy remaining.
The Powerbank has an LCD display, which displays the capacity of the
Powerbank in percent (0% - 100%).
> CHARGING THE POWERBANK:
Insert the Micro-USB plug of the USB cable into the Micro-USB socket
on the POWERBANK and the USB plug into the USB port on a computer
or a USB charger.
The charge process starts automatically. During the charge process,
the "IN" indicator flashes and the charge progress is displayed in
1% percent steps. After the charging is complete, the 100% display
appears.
> CHARGING DEVICES:
In order to charge a device, such as a smartphone for example, please
use the USB cable supplied (provided that the Micro-USB plug fits
your mobile device) or the original charge cable for your device. Insert
the USB plug of the cable into the POWERBANK and the other end into
your device. The charge process starts automatically. If the charge
process does not start automatically, please press the power button.
The "OUT" indicator appears in the display and the capacity display
in percentage steps disappears ca. 30 seconds after the device is
attached.
Simultaneous charging of multiple end-devices is possible with res-
trictions. This depends on the total charge current required.
The POWERBANK switches off automatically after the charging is com-
plete. Please disconnect your device from the POWERBANK once the
charge process is complete. Please note that the Powerbank cannot
be charged and discharged simultaneously.
> LED LAMP
The LED can be activated and deactivated by pressing the button for
2 - 3 seconds.
The POWERBANK may heat up a little depending on the charge/
discharge current.
Deutsch | English | Français | Español | Português
Italiano | Nederlands