Replacement Filter Assembly; To Store Your Accessories; Insert Hose - RIDGID WD1245 Manual Del Propietário

Replacement Filter Assembly

1. Carefully slide the filter over the filter
cage. Line up hole in filter plate with
threaded stud and slide it down until the
filter stops against the plate.
2. Place filter nut onto threaded screw and
tighten it down. Finger tighten only.
NOTE: Lever of filter nut should be away
from filter as shown.
IMPORTANT: Do not overtighten as this
may deform or crack the filter cage.

To Store Your Accessories

1. Slide extension handles and accesso-
ries over the rings on the caster feet.
2. To remove handles and accessories,
lightly rotate and pull upward.
3. Accessories may also be stored in the
rings provided on lid.

Insert Hose

Insert the push button end of the "Tug-A-
Long" hose into the inlet of the vac. The
hose should snap into place. To remove
the hose from the vac, press the release
button in the hose assembly and pull the
hose out of the vac inlet, as shown.
Release Button
5
Filter Nut
Filter Plate
Filter
Filter
Cage
Plate