Product Features - HoMedics FB-350-EU Manual De Instrucciones E Información De Garantía

PRODUCT FEATURES:

Splash guard
Enjoy a relaxing
vibration massage
Keep Warm: helps to
maintain water temperature
for longer. This is automatically
activated when the vibration massage
function is switched on.
Figure 1 Figure 2
INSTRUCTIONS FOR USE:
1. Unfold the foot spa by pulling up the edge one side at a time while holding
the base firmly (figures 1 - 3).
2. Use the anti-collapse system to lock the unit. To do this, pull out the metal
props at the front and back of the foot spa and push them into place under
the edge of the tub (figures 4 & 5).
3. Ensure that the unit is unplugged before filling with water. Fill with warm
water to the MAX fill line located on the inside of the tub.
NOTE: Heat will only help to maintain the temperature of water
placed inside the footspa. It will not heat cold water. For a warm
water massage, fill the unit with warm water.
4. Place the unit on the floor in front of a chair. It is recommended to place the
product on a towel.
5. Plug the unit into a 220-240 AC power supply.
6. Sit down and place your feet in the spa.
Figure 3 Figure 4
7. To operate the unit, press the power button on the back of the product.
NOTE: The keep warm function is automatically activated when the
vibration massage is switched on. The vibration massage + keep
warm must only be used with water.
8. Enjoy a deep massage by sliding feet back and forth over the stimulating
acunodes on the footspa floor.
9. If desired, dissolve a small amount of bath salts into the water for a
refreshing bathing experience.
10. To turn off, press the buttons again to deactivate.
11. To empty, unplug the unit from the mains and pour water away.
12. To store the foot spa, unlock the anti-collapse system by unclipping the
metal props from under the edge of the tub and folding them away. Then
fold the foot spa down by pressing down on the edges while holding the
base firmly.
3
Acu-nodes: stimulate the
acupressure points on the sole
of the foot.
MAX fill line
Power switch
Figure 5