Control Panel Operation - Friedrich KCS08 Manual De Instalación Y Funcionamiento

Control Panel Operation

All of the control panel function buttons and mode icons can be viewed in Figure 8.
Power On – Press the button to turn on the air conditioner. The power button illuminates to indicate that the power is on. The backlight on the power switch
will automatically turn off after 20 seconds of inactivity. The remote control can also be used to turn power ON / OFF (see Remote Control).
Display – The display is a high efficiency LCD with a built-in backlight. After 20 seconds of inactivity, the display switches off. Touching any button
automatically changes the display to full brightness.
There are three control push buttons on each side of the display.
Figure 8
SYSTEM FAN MODE
Cycles between Sets fan to either:
AUTO, HEAT, - Cycle automatically
COOL, or FAN - Run continuously
ONLY
(if equipped)
Figure 9
MODE
Cycles between
COOL, HEAT, FAN
ONLY or -AUTO-
(if equipped)
FAN
Sets fan to either:
- Automatically cycle
- Continuously run
FAN SPEED TEMPERATURE
Increment UP
Sets fan speed:
LOW, MED,
HIGH or AUTO
TEMPERATURE
(if equipped)
Increment DOWN
COOL HEAT FAN ONLY -AUTO-
Automatically switches
between cool & heat
FAN SPEED 2 DIGIT DISPLAY
Sets fan speed: Shows Setting for:
LOW, MED, HIGH, OR MAX - Set Point (Temperature)
(Actual settings are - Clock (AM/PM)
model dependant)
TIMER
Turns ON or OFF
DISCONNECTED CONTROL
FROM POWER BOARD LOCKED
FILTER TIMER
Check / clean shows on or off
IR WINDOW ON / OFF
Do not block Turns unit on/ off
WI-FI OPERATING
STATE
9