Stiebel Eltron SunWarmth CIR 150-1 I Guía De Funcionamiento E Instalación página 18

INSTALLATION
INSTALLATION
8. Slide lamp wires out of electrical connection box. Set electrical
connection box aside:
9. Remove interior end plate from heater: 6 Phillips screws fasten
the heater body end plate in place:
10. Slide top cover plates out each end of top side of heater:
18 |SUNWARMTH ™ CIR INFRARED HEATER
11. Remove the center face plate:
The BOTTOM edge of the center Face Plate does not have a
»
lower lip
Insert a fine edged slot screw driver between the heater body
»
and the BOTTOM edge of the face plate
Pry the face plate from the heater body, and remove to storage:
»
12. Slide the end face plates out from each end of the heater:
13. NOTE: For this step, keep the heat lamp retainer clips in place
at each end of lamps. Heat lamp is fragile - use caution when
feeding wires through holes.
Carefully feed each lamp wire from the top of the heater through
»
the hole in the heater body so that the wire is inside the heater
body (same as the lamp):
WWW.STIEBEL-ELTRON-USA.COM