Sub-Zero ICB700TR Guía De Uso Y Mantenimiento página 22

T R O U B L E S H O OT I N G
F R E Q U E N T LY A S K E D
I C E P R O D U C T I O N
IMPORTANT NOTE: Make sure that the ice
maker system is turned on. If it is, the word
ICE will be displayed in the LCD display on the
electronic control panel.
IMPORTANT NOTE: The first container filled
with ice should be discarded, as with any new
connection there may be impurities in the ice
from the water supply line.
Q:
A:
Q:
A:
Q:
A:
N O I S E
Q:
A:
22
Q U E S T I O N S
My ice maker isn't producing very much ice.
On average, you can expect a cycle of ice
(eight cubes per cycle) every two hours.
My ice is freezing together and clumping.
If ice is not used regularly it tends to fuse
together. You may need to discard the ice
and allow ice to be replenished. Some
types of filter systems or incorrect water
pressure issues may cause this condition.
My ice tastes funny and is discolored.
Sub-Zero Integrated units do not have an
integrated water filtration system. Contact a
local plumber to discuss water filtration
options.
Why do I hear my unit running constantly?
It is normal to hear the operation of fans
and compressors. Sounds will be accentu-
ated based on the placement of the unit
and overall room design.
Model ICB700TFI uses a variable speed
compressor. With this high-efficiency
design, it is normal for the compressor to
run continuously and will actually use less
energy than a typical on-off design.
G U I D E
T E M P E R AT U R E
IMPORTANT NOTE: Unless the unit is being
serviced, make sure the power for your unit is
on.
Q:
A:
Q:
A:
Q:
A:
Q:
A:
D O O R O P E R AT I O N
Q:
A:
Q:
A:
How do I adjust the temperatures?
To adjust temperatures, refer to Tempera-
ture Control, page 11.
What are the suggested temperature
settings?
The recommended settings are 3ºC for
refrigerator zones and -18ºC for freezer
zones.
Condensation is forming on the inside and
outside of my unit.
In climates with higher humidity, condensa-
tion will form and is considered normal.
Leaving the door open for a long period of
time may also contribute to condensation
forming on the inside your unit.
My unit isn't cooling properly.
Clean the condenser area as outlined on
page 17.
Why is my door hard to open?
Your unit was designed for an airtight seal.
A vacuum seal can form after the door is
closed. Wait several seconds for pressure to
equalize before reopening the door.
The door on my unit is opening too fast and
hitting the wall or surrounding cabinets.
The unit may not be leveled properly or a
door stop may be required. To adjust the
built-in door stop, refer to 90-Degree Door
Stop, page 19.