Operation Of The Appliance; Moving The Appliance - TESY MC 2014 Instrucciones De Uso Y Almacenamiento

OPERATION OF THE APPLIANCE

EN
Remote control
Connect the power cord after ensuring that voltage
1.
supplied to your home corresponds to the values on
the appliance technical plate.
In order to provide power supply to the panel
2.
heater, turn the power button to position I – the
display will flash for a while.
You can use the touch panel or the remote control
3.
to adjust the panel heater
Push button
4.
heater will operate at its maximum power (2000W)
and the display will show the value of the room
temperature
Using the buttons
5.
whether the panel heater to operate at half of its
power (1000W) or at its full power (2000W). That is
indicated by lights at the right corner of the display
•
One light on – half power 1000W.
•
Two lights on – full power 2000W
Setting the timer
6.
•
Push button
0:00
•
Using the buttons
number of hours from 0 to 18 (the available options
are at 30-minute intervals) in order to adjust when
the panel heater to stop its operation
•
When adjusting the timer in Heating mode – the
appliance will turn off after the selected time period.
4
Usage and Storage Instructions
LED Display
Temperature increase/
decrease and time
adjustment button
Temperature
adjustment button
Timer button switching
on/off
ON/OFF button
, to turn on the appliance. The panel
and , you can select
- the display will show indication
and , one can set the
In Stand-by mode:
•
Step 1: you must to set the time, from 0 to 18 hours.
For example 2 hours.
•
Step 2: you must to set the temperature. For
example 20 °C.
•
Step 3: you must to set the power. (The default
power: 2000W)
•
After 2 hours, if the room temperature is lower than
20 °C, heater will start to work..
Noted: you must set the timer firstly, and then you
can set the temperature
Setting the thermostat
7.
•
In order to set the room temperature you desire –
push button
•
Using the buttons
desired temperature in the range from 5 to 36
degrees Celsius
•
Digital display will start blinking showing the user
selected temperature.
•
After 5 seconds the display will stop blinking and
will show the room temperature.

MOVING THE APPLIANCE:

If it is necessary to move the appliance to another
place of operation, switch it off by pulling the power
plug out of the socket, holding the appliance handles
with both hands, move it to its new position, having
in mind that the appliance must get cold (cooled
down) before doing this. Moving hot appliances may
lead to bad consequences for the user like burns or
inflammable materials entering the panel heater during
its movement.
IN-BUILT OVERTURN (FALL) PROTECTION SWITCH
The panel heater has got an in-built overturn protection
switch. In case the panel heater overturns, the power
supply will be stopped. Let the panel heater cool
down and then put it into upright position again. The
appliance will restore its normal operation.
AUTOMATIC SAFETY STOP
There is an in-built device in the panel heater (self-
restoring thermal switch), which actuates automatically
and switches off the panel heater in case of overheating.
The thermal switch will restore its normal state when
the appliance temperature decreases to its normal level.
and you can adjust the