Controls, Indicators And Connectors; Front Panel Description - Agilent Technologies TwisTorr 84 FS AG Serie Manual De Instrucciones

Controls, Indicators and Connectors

The following paragraph illustrates the Controller control panel and
interconnection panel. More details are contained in the appendix
"Technical Information".

Front Panel Description

Figure 2
1 Keyboard push-button to recall on the display the cycle number, cycle time and pump life.
2 Keyboard push-button for LOW SPEED mode selection. It is active only when the front panel
operation has been selected. Pressed once, the pump runs at "stand-by" speed. To unselect
the mode, press the push-button again.
3 Keyboard push-button to recall on the display the "pump current", "pump temperature",
"pump power" and "rotational speed". It is always active regardless of the operating mode
selected. Push-buttons 3 and 1, if pressed together for at least 2 seconds, put the controller in
a routine where it is possible to program some operation parameters.
4 Keyboard push-button for START, STOP/RESET mode selection. It is active only when the
front panel operation has been selected. By pressing once the starting phase begins; if
pressed again it stops the pump. If the pump has been stopped automatically by a fault, this
push-button must be pressed once to reset the controller and a second time to restart the pump.
5 LCD back-lighted alphanumeric display: dot matrix 2 lines x 16 characters.
TwisTorr 84 FS AG Rack Controller User Manual / 87-901-037-01 (D)
5
LS
AG
1
VACUUM TECHNOLOGIES
COUNTERS
increase
2
decrease
LOW SPEED
TwisTorr 84 FS AG Turbo-V 301-AG
Controller TwisTorr 84 FS AG Front Panel
Instructions for Use
R1
R2
MEASURES
next
menu
previous
START/STOP
16
Use
3
4
201/300