Publicidad
Idiomas disponibles
Idiomas disponibles
INSTRUCTIONS MANUAL
Smoke detector
C-LOGIC 700-SD
SKU: CLOGIC700SDCBINT
ENGLISH
SHAPE AND SIZE (mm) (Figure 1)
SHAPE AND SIZE (mm) (Figure 2)
TECHNICAL PARAMETERS:
Working Voltage
Current
Alarming Decibel
HUSH Status
Standby status
Low battery status
LED Indicator
Low voltage Alarming
Working Temperature
Working Humidity
Certifications
Intended for Fire Safety and installed in
buildings
EN
9V DC(re-commanded battery:6F22,GP
1604S,GP 1604A,PAIRDEER 6F22,OSEL
6LR61,PAIRDEER 6LR61,FORTE
ER9V,EVE CR-9V,ULTRALIFE ULVL-
J,FANSO ER9V)
Quiescent Current:
< 12uA
Alarming Current:
< 20mA
≥ 85dB/3m
LED flashes every 10 sec.
LED flashes every 43 sec.
special low battery beep around every 43
sec.
LED (red)
≤ 7,35V
-10º ~ +40º
< 95% HR
EN 14604:2006/AC:2009
Essential characteristic 1: Pass
Essential characteristic 2: Pass
Essential characteristic 3: Pass
Essential characteristic 4: Pass
Essential characteristic 5: Pass
Essential characteristic 6: Pass
Essential characteristic 7: Pass
Essential characteristic 8: Pass
TEST AND BEFORE INSTALLATION
Note: If the battery is not installed correctly, the detector will not work and maybe destroyed.
If the detector operates smoothly, the Red LED will flash once in about 43 sec..
• Take the product out of the packaging,take off the installation base from the product via
rotating the product on the anti-clockwise direction.
• Take out the 9V battery from battery compartment, remove the insulation film from the
battery, connect the battery to battery buckle and put it back to battery compartment.
• Depress(keep depressing and release till finish the testing) the test/hush button
RED LED flashes quickly and in the meanwhile the detector sounds, which means the the
detector works well. At the same time the product goes into low sensitivity detection mode,
round 10 minutes later the product goes into standard sensitivity detection mode again.
INSTALLATION (see Figure 2)
Choose a right place to install the smoke alarm.
The alarm may not be mounted in:
• a room in which the temperature can reach below 4 and above 40ºC
• in damp spaces
• just in front of doors or windows and not near a ventilator or radiator
• Maintain a distance of at least 50 cm from fluorescent lights or low-energy bulb
MAINTAIN AND USE
• Test the smoke alarm weekly and after battery replacement.Test the alarm for normal
operation using the test facility when the battery is replaced. mediante la función de
prueba cuando cambie la pila.
• If the product does not work properly, please check the product according to Failure
Analysis and Troubleshooting part as below.If the product still can not work please contact
your local dealer and do not open the product by yourself.
FAILURE ANALYSIS AND TROUBLESHOOTING
Failure
Cause Analysis
No reaction from product when
9V battery may not installed
depress test button
properly
Low battery beep around every
Low voltage of 9V battery
43 sec.
NOTICE
• This product is not re-commanded to be installed in humidity,dusty, high temperature
place like Kitchen or bathroom
• During the installation please make sure that there will be no other obstacle which may
cover the flash light or alarm sound from the smoke alarm.
• Smoke alarm can not work if the battery is not connected to the right battery polarity, and
the product may also be destroyed because of this.
FULL MANUAL DOWNLOAD
MANUFACTURER:
MGL International
APAC: MGL GLOBAL SOLUTIONS LTD
info.apac@mgl-intl.com
Flat 4-1, 4/F, No. 35, Section 3 Minquan
East Road. Taipei, Taiwan.
Tel: +886 2-2508-0877
EMEA: MGL EUMAN S.L.
info.emea@mgl-intl.com
Parque Empresarial Argame, 33163
Morcín. Asturias, Spain.
Tel: +34 985-08-18-70
Remedy
Installed the 9V battery
with right Battery
polarity
Replace the battery
You can download the complete manual
at the URL
https://clogic-intl.com/clogic-700-sd
AMERICAS: MGL AMERICA, LLC.
info.na@mgl-intl.com
US East Coast: 2810 Coliseum Centre
Drive, Ste. 100. Charlotte, North Carolina,
28217 USA
Tel: +1 833 533-5899
US West Coast: 760 Challenger Street.
Brea, California 92821 USA
Tel: +1 310-728-6220
www.mgl-intl.com
the
Publicidad
