Transport, Putting Into Operation And Decommissioning; Transport; Putting Into Operation; Storage And Recycling - Hupfer SW Manual Del Usuario

Section 4
Page 22
4

Transport, Putting into Operation and Decommissioning

4.1

Transport

ATTENTION
Serving Trolleys are delivered as an assembled unit, i.e. they are completely assembled.
When loading, use only hoists and load lifting devices approved for the weight of the appliance. Only
transport vehicles that are approved for the weight of the appliance may be used.
The scope of delivery is specified in the shipping documents in accordance with the valid purchase agree-
ment and included with the delivery item.
4.2

Putting into Operation

Remove the original packaging and check whether the appliance is complete and undamaged. Do not put a
defective appliance into operation under any circumstances and inform the supplier immediately in such a
case.
Always place the Serving Trolley on firm and level floors when unpacking and operating it. Apply the total
locks on both swivel casters to secure the appliance against rolling away.
INFO
The Serving Trolley should be thoroughly cleaned with a soft cloth before putting it into operation for the first
time. Ensure that the appliance is clean and dry before putting it into operation.
The following appliance functions must be checked before putting it into operation:
§
the functioning of the total locks.
4.3

Storage and Recycling

Appliances must be kept in a dry, frost-free environment when placed in temporary storage. The Serving
Trolley must be kept covered with a suitable covering material to be protected against dust ingress.
The appliance kept in the storage location must be checked for damage and corrosion every 6 months.
NOTE
The appliance must be clean and dry before it is placed back into use.
Serving Trolley
SW | SW ERGO | SSW | SSW ERGO | MSW | MSSW
Transport, Putting into Operation and Decommissioning
Damage to appliances caused by improper transport
Appliances should be safely secured when transported off site inside a vehicle
such as a truck. The total locks are not suitable for securing the appliances
when they are transported in a vehicle.
If the appliances are not secured properly, there is a risk of damage to proper-
ty and harm to persons caused by squashing.
Secure each individual separate appliance using suitable transport securing
devices.
Disposal of packing material
The packing consists of recyclable materials and can be disposed of accord-
ingly. The different materials should be separated and disposed of in an envi-
ronmentally friendly manner. The local agencies responsible for disposal must
be contacted regarding removal
Condensation
Ensure that there is sufficient ventilation and no major variations in tempera-
ture in the storage location, so that condensation is prevented from forming.
Transport
91337781_A0