Installation Of The Download Module; Connection Between Download Module And Datalogger; Connection Between Download Module And Pc - Carel DownLoad DLOGSER000 Manual De Utilización

In the case of more than one Datalogger (N) and only one DownLoad Module, there are two possibilities:
order the required number (N-1) of IR Units separately;
order 'N' telephone cables and 'N-1' "T" connectors, as per the diagram below:
SERIAL ADDRESS 1 SERIAL ADDRESS 2
sensor 1 sensor 2 sensor 1 sensor 2
Unit IR
Telephone
cable
Connect the IR unit to
the free connector
Connection Power
start start
Press start:
1 sec. to download partial data
3 sec. to download all data
1 sec. to transfer data to PC
10 sec. to clear module flash memory
Infrared
Download Module
Module
Installation of WinLog (see on page 41)

Installation of the DownLoad Module

Place the batteries in the DownLoad Module battery compartment, observing the polarity indicated.
The transformer can be used as an alternative to the batteries by connecting it to the socket on the side of the
DownLoad Module.
If the transformer and batteries are used together, the power is supplied by the transformer, and the batteries
are neither damaged nor discharged.
Connection between Module and Datalogger
No electrical connection is required for communication between a Datalogger and the DownLoad Module, as
it uses an infra-red beam. The Module's infra-red transmitter covers a maximum distance of 2 metres with an
angle of 60 degrees.
Important: on the Datalogger you must set a serial address different from 0 (default value).
SERIAL ADDRESS 3 SERIAL ADDRESS n
sensor 1 sensor 2 sensor 1 sensor 2
Telephone Telephone
cable cable
Conn. "T" Conn. "T"
3 Wires: 3,4,5
36

Connection between DownLoad Module and PC

Use the Modem-PC cable to connect the 25-pin connector (female) of the DownLoad Module to the RS232
serial port (male) of the PC.
The basic connection diagram is as follows:
Telephone
cable
Conn. "T"
NETWORK
Transformer
Fig. 7
sensor 1 sensor 2
IR Unit
IR Connection
232 Connection
Connection Power
start start
Press start:
1 sec. to download partial data
3 sec. to download all data
1 sec. to transfer data to PC
10 sec. to clear module flash memory
Optional
Infrared
Download Module
Module
37
Winlog
Fig. 8