Operating Instruction - Jilong PATHFINDER Serie Manual De Instrucciones

INFLATING THE KAYAK
After the inflation adapter is assembled completely, you can inflate the kayak by
number sequence. Do not over inflate. After inflating screw the valve cap A in
clockwise direction by hand.
Fill each chamber until it is stiff. Measure the printed ruler to 10cm with the
equipped hard ruler to check the main chamber for proper inflation.
Caution: Do not over inflate or use a high-pressure pump. The maximum
pressure for air chamber.
0.15bar(2.18PSI) for chamber 1,2
0.10bar(1.45PSI) for chamber 3
Inflating:
- Unscrew the valve cap A, assemble the Inflation Adapter with inflating mouth B,
air pressure meter and the air pump.
Caution: Do not over inflate, or use a high-pressure pump!
Deflating:
Remove the valve cap A, push down the deflation button C and turn the valve
clockwise direction by 90° until its is locked, release the valve and the air will flow
out. If you want to stop the deflation, push down the deflation button C and turn
it in counter-clockwise direction by 90°. The deflation will stop when the valve is
released.
8 www.jilong.com PK-13-GB(V1)
INFLATING THE KAYAK
Assembly of the oar

OPERATING INSTRUCTION

Install the direction fin on the bottom of Kayak. Please refer to below illustration.
9
www.jilong.com PK-13-GB(V1)