Craftsman 171.254841 Manual Del Propietário página 17

TABLE TOP INSERTS TO THE ROUTER TABLE
This router table comes with three table top inserts in
the following hole sizes:
o 1-1/4" diameter, for use with router bits with diame-
ters up to 1-1/8"
• 1-7/8" diameter, for use with router bits with diame-
ters up to 1-3/4"
o 2-1/8" diameter, for use with router bits with diame-
ters up to 2"
• For router bits with diameters between 2" and 2-3/4"
the table top inserts are not used. See Figure 22.
FIGURE 22
I,_WARNINGJ
A 2-3/4" diameter router bit is the
LARGEST router bit that can be SAFELY used on
this router table.
1. Select the table top insert that accommodates the
router bit to be used.
2. Assemble the insert to the table top by pressing it
into the large hole in the top of the router table, as
shown in Figure 23.
3. Press down equally over the tabs on the insert so
that the tabs snap into place.
4. To remove, insert a finger in the insert hole and
gently pull up until the tabs disengage the hole.
When not in use. store the inserts in a convenient
place.
[,_WARNING] DO NOT attempt to remove insert
from the table top unless the router bit has been
removed from the router.
FIGURE 23
17