Getting Started - auna 388 DAB+ Manual Del Usario

EN
34

GETTING STARTED

Precautions for use
Installation: Unpack all parts and remove protective material. Do not
connect the unit to the mains before checking the main voltage and
before all other connections have been made. Do not cover any vents and
make sure that there is a space of several centimeters around the unit for
ventilation.
Connection
1. Plug in the AC cord (33) to the AC outlet. The unit will go to standby
mode and the LCD display (2) will dim light up.
2. Turn on the unit (6), if the LCD display (2) is on with backlighting, it
means the power supply is normal. Now your system is ready to play the
music.
Setting the clock
1. Set unit in standby mode.
2. Press and hold the "Mem/Clk-Adj" button (12) until display will flash
"24HR". press the Skip Up or Skip Down button (23/13) to select the
clock format between 12 or 24Hour. Then press the "Mem/Clk-Adj"
button (12).
3. The first digit of "0:00" is flashing on the LCD display (2). Press Skip Up
or Skip Down button (23/13) to set the correct hour. Press "Mem/Clk-
Adj" button (12) to store the correct hour.
4. The third & fourth digit of "00" is flashing; press the Skip Up or Skip
Down button (23/13) to set the correct minutes. Then press "Preset/Clk-
Adj" button (12) to store the correct minute.
• The clock setting mode will automatically quit if no button is being
pressed in a period of about 5 seconds after pressing the "Mem/Clk-
Adj" button.
• The pre-set time will be re-set completely if dis-connecting the main
power supply except backup battery installed. You are recommended to
switch the system into standby mode for convenience usage.