Install Brushcutter Blade To The Cutting Head; Install Handle - Briggs & Stratton Murray 866015 Manual Del Usuario

Install Brushcutter Blade to the cutting Head

1. Align the hole on the cutting head (a, Figure 12) to the
notch (B) on the spline pad (c).
2. Use Allen Wrench (D) to hold spline pad in position.
3. While holding Allen wrench in place, install the blade
(e), clamp cup (F), protective cup (G), lock washer (H)
and locknut (J).
NOTe: Ensure that the spline pad is placed in the correct
position when installing. The shoulder side must
face the cutting head.
D
c
F
H
Figure 12
aSSeMBlY

Install Handle

1. Turn the red knob counterclockwise to loosen the
handle cap assembly.
2. Place the handle inside the cap assembly as shown
(Figure 13) and turn the red knob clockwise to tighten.
3. The handle should be placed into a position that is
comfortable and that allows for proper trimming
operation practices.
a
B
Figure 13
e
NOTIce: When rotating the handle for storage or assembly,
Do Not allow the cable (Figure 15) to wrap around the
handle cap assembly, or the cable may become damaged
or disconnected.
G
J
Figure 14
13