Briggs & Stratton Generac PowerBoss 5500 Watt Storm-Plus Manual Del Usuario página 8

RECEPTACLES
120/240 Volt AC, 30 Amp, Locking
Receptacle
Use a NEMA L14–30 plug with this receptacle. Connect a
4–wire cord set rated for 250 Volt AC loads at 30 Amps (or
greater) (Figure 7).You can use the same 4–wire cord if you
plan to run a 120 Volt load.
Figure 7 — 120/240 Volt AC, 30 Amp, Locking Receptacle
This receptacle powers 120/240 Volt AC, 60 Hz, single
phase loads requiring up to 3,600 watts of power at
30 Amps for 120 Volts; 5,500 watts of power (5.5 kW) at
30 Amps for 240 Volts.The outlet is protected by a 20 Amp
push–to–reset circuit breaker.
CAUTION!
Although this outlet states it has a
120/240 Volt 30 Amp rating (up to 7,200 watts), the
generator is only rated for 5,500 watts. Powering
loads that exceed the wattage/amperage capacity of
the generator can damage it or cause serious injuries.
Downloaded from https://needmanual.com/
PowerBoss 5,500 Watt Storm-Plus Generator
120 Volt AC, 20 Amp, Duplex
Receptacles
Each receptacle (Figure 8) is protected against overload by
a 20 Amp push–to–reset circuit breaker.
Figure 8 — 120 Volt, 20 Amp Duplex Receptacle
Use each receptacle to operate 120 Volt AC, single–phase,
60 Hz electrical loads requiring up to 2,400 watts (2.4 kW)
at 20 Amps of current. Use cord sets that are rated for
125 Volt AC loads at 20 Amps (or greater).
8