CIAT CS2B Manual De Instalación página 13

  
¹¾½ÌÑ »ÇÆËÁ¼½Ê¹ÌÁÇÆ
Read and follow manufacturer instructions carefully.
Follow all local electrical codes during installation. All
wiring must conform to local and national electrical codes.
Improper wiring or installation may damage the NUI.
Understand the signal words DANGER,WARNING, and
CAUTION. These words are used with the safety-alert
symbol. DANGER IDENTIlES THE MOST SERIOUS HAZARDS
which will result in severe personal injury or death.
WARNING SIGNIlES A HAZARD WHICH COULD RESULT IN
personal injury or death. CAUTION is used to identify
unsafe practices which may result in minor personal injury
or product and property damage.
NOTE is used to highlight suggestions which will result in
enhanced installation, reliability, or operation.
ÇϽÊ
The NUI will be powered with 12V unregulated DC
Voltage. This power is supplied to the User Interface by
the unit to which is connected.
Ì½È Ë½Ê Æ̽ʾ¹»½ Ç»¹ÌÁÇÆ
s !PPROXIMATELY  FT M FROM mOOR
s #LOSE TO OR IN A FREQUENTLY USED ROOM PREFERABLY ON
an inside partitioning wall.
s /N A SECTION OF WALL WITHOUT PIPES OR DUCT WORK
User Interface should NOT be mounted.
s #LOSE TO A WINDOW ON AN OUTSIDE WALL OR NEXT TO A LID
leading to the outside.
s %XPOSED TO DIRECT LIGHT OR HEAT FROM THE SUN A LAMP
lREPLACE OR OTHER TEMPERATURE RADIATING OBJECTS
which could cause a false reading.
s #LOSE TO OR IN DIRECT AIRmOW FROM SUPPLY REGISTERS AND
return--air registers.
s )N AREAS WITH POOR AIR CIRCULATION SUCH AS BEHIND A LID
or in an alcove.
Ì½È ÆË̹ÄÄ Ë½Ê Æ̽ʾ¹»½
WARNING: ELECTRICAL OPERATION HAZARD
Failure to follow this warning could result in personal
injury or death. Before installing User Interface, turn off
all power to equipment. There may be more than one
power to disconnect.
1. Turn OFF all power to unit.
 )F AN EXISTING 5SER )NTERFACE IS BEING REPLACED
s 2EMOVE EXISTING 5SER )NTERFACE FROM WALL
s $ISCONNECT WIRES FROM EXISTING 5SER )NTERFACE
one at a time.
s !S EACH WIRE IS DISCONNECTED RECORD WIRE COLOR
and terminal marking.
3. Open the NUI (mounting base) to expose mounting
holes. The base can be removed to simplify mounting.
Press the thumb release at the top of the NUI and
snap apart carefully to separate mounting base from
remainder of the NUI.
4. Route the NUI wires through large hole in mounting
base. Level mounting base against wall and mark wall
through 2 mounting holes. See Fig. 1.
Á¿ ¹»Ã ÈĹ̽ ÇÍÆÌÁÆ¿
5. Drill two 5 mm mounting holes in wall where marked.
6. Secure mounting base to the wall with 2 anchors and
screws provided making sure all the wires extend
through hole in the mounting base.
13