CIAT CS2B Manual De Instalación página 15

When power is applied, all display icons are lit for 2
seconds to test the display.
&OLLOWING THIS UNIT CONlGURATION IS DISPLAYED FOR AN
ADDITIONAL  SECONDS IT WILL BE HEATING COOLING (0 OR
heating only (HO) or cooling only (AC).
4O %NTER THE )NSTALLER #ONlGURATION -ODE
Press zone ( ) and hold ( ) buttons simultaneously
FOR  SECONDS THE PARAMETER NUMBER WILL BE mASHING ON
the timing-zone and parameter value will be displayed in
temperature-zone of the display.
To modify parameters value, follow steps 3 to 8 of
paragraph hChanging user settingsv.
3 sec
Parameter number (ref table 1)
ÆË̹ÄÄ½Ê »ÇÆ ¿ÍʹÌÁÇÆ ¼½¾¹ÍÄÌ Ê½Ë½Ì
Press zone ( ) and hold ( ) buttons at a time for 10
SECONDS TO ENTER INTO THE INSTALLER CONlGURATION MODE
7HEN THIS SETTING IS lRST SELECTED  SHALL BE DISPLAYED
in the temperature zone and an initial value of 10 shall be
displayed in the time-zone of the display. Press and hold
the down button.
7HEN THE COUNTER REACHES ZERO h&Dv SHALL BE DISPLAYED IN
the temperature-zone of the display. This represents
factory defaults are in progress. Upon successful
completion of restoring defaults to EEPROM, the NUI
shall than force a reset.
15