Publicidad
PROJECT 613 • PROJECT 614
Fig. 35
NEVER hang a swing seat by a
partial link of chain! Remove and
discard partial links.
Fig. 36
Fig. 34
R. Final Assembly.
1.
Hold the swing seat vertically and insert uncoated chains
through the channels on the bottom of the swing seat.
Note: A coat hanger may be used to help pull chain through
the swing seat. One full link should show at each end of the
seat (Fig. 34).
2.
Place one covered chain onto each harness so that it fits at
the top of the V-hanger. Insert uncoated chains to bottom
vinyl hooks of V-hanger. (Fig. 36). Crimp harness end
closed. CAUTION: It is important that you crimp
harness ends completely closed before using
(see Fig. 36). Place end of harness with hooks on a hard
surface and force hooks closed with a hammer or squeeze
closed with a pliers until parts are touching. WARNING:
Open hooks can cause deep cuts.
3.
Hang the chains from the nylon bushing swing hangers.
Crimp the hook opening closed with a pliers to secure the
chains to the swing hangers (Fig. 37). Make sure all
connections are tightly crimped and secure before using
swing seat.
Fig. 37
47
614
614
613
613
Publicidad
