Publicidad
Fig. 35
NEVER hang a swing seat by a partial
link of chain! Remove and discard
partial links.
Fig. 36
Fig. 34
R. Final Assembly.
1.
Hold the swing seat vertically and insert uncoated chains
through the channels on the bottom of the swing seat. Note: A
coat hanger may be used to help pull chain through the swing
seat. One full link should show at each end of the seat
(Fig. 34).
2.
Place one covered chain onto each harness so that it fits at
the top of the V-hanger. Insert uncoated chains to bottom vinyl
hooks of V-hanger. (Fig. 36). Crimp harness end closed.
CAUTION: It is important that you crimp harness ends
completely closed before using (see Fig. 36). Place end of
harness with hooks on a hard surface and force hooks closed
with a hammer or squeeze closed with a pliers until parts are
touching. WARNING: Open hooks can cause deep cuts.
3.
Hang the chains from the nylon bushing swing hangers. Crimp
the hook opening closed with a pliers to secure the chains to
the swing hangers (Fig. 37). Make sure all connections are
tightly crimped and secure before using swing seat.
Fig. 37
32
Publicidad
