Mark MINIBEAM XTREME Instrucciones De Usuario página 6

EN
Controls
Link all DMX devices with a DMX-512 controller by using a standard,3-pin DMX cable.Connect the output
of the first device with the input of the second device and the output of the second device with the input of
the third device and so on.
Connect the mains plug to an outlet.
Operating the product for the first time may generate smoke and odour,this is not a defect.Avoid
dis/connecting the product repeatedly and quickly from/with mains!Always wait 15 minutes prior to the next
dis/connection!
7. Lamps
During operation,the lamps will reach temperatures of up to 600
burns!Objects coming into contact with the lamps during and shortly after operation may catch fire!
Disconnect the product from mains prior to installing or before changing a lamp!Allow a lamp to cool for
approx.15minutes before exchanging it!
Never touch a lamp with bare hands!If damaged or deformed,a lamp must be exchanged!
When exchanging the lamp be sure to use suitable lamps only.Lamps with greater performance generate
excessive heat for the product;risk of fire!Damage resulting from the use of an unsuitable lamp is exempt
from warranty!
Never connect the lighting effect to the mains prior with opened housing.
8. Fuse
from the mains prior before changing a fuse.
Only replace the fuse by a fuse of same type and rating! An incorrect fuse could damage of destruct the
lighting effect.
Replace a fuse by levering the fuse holder cover with an appropriate screwdriver.Remove the old fuse and
MINIBEAM XTREME
ATTENTION：
DANGER OF LIFE！ RISKOF FIRE！
RISK OF SHORT CIRCUIT！
ATTENTION：
DANGER OF LIFE！ RISKOF FIRE！
RISK OF SHORT CIRCUIT！
User Manual/Manual de uso
O
C.Touching the lamps may cause serious
Disconnect the product
P 5