Weber 300 Guia Del Propietario página 24

24
LIGHTING
Summary lighting instructions are posted on the cart leg under the control knobs (L).
Failure to open the lid while igniting the barbecue's burners,
or not waiting 5 minutes to allow the gas to clear if the
barbecue does not light, may result in an explosive flame-up
which can cause serious bodily injury or death.
1).
5).
3).
1) Open the lid.
2) Make sure all burner control knobs are turned OFF. (Push control knob in and turn
clockwise to ensure that it is in the OFF position.)
WARNING: The burner control knobs must be in the OFF
position before turning on the liquid propane cylinder tank
valve. If they are not in the OFF position, when you turn on
the LP cylinder valve, the "excess gas flow control" feature
will activate, limiting the flow of gas from the LP cylinder. If
this should occur, turn OFF the LP cylinder valve and burner
control knobs. Start over.
When the "excess gas flow control" feature is activated,
a small amount of gas is still flowing to the burners. After
turning OFF the cylinder valve, wait at least 5 minutes for the
gas to clear before attempting to light the barbecue. Failure
to do so may result in an explosive flame-up, which can
cause serious bodily injury or death.
OPERATING INSTRUCTIONS
DANGER
6).
2).
L).
DANGER:
WARNING: Check hose before each use of barbecue for
nicks, cracking, abrasions or cuts. If the hose is found to
be damaged in any way, do not use the barbecue. Replace
using only Weber ® authorized replacement hose. Contact
the Customer Service Representative in your area using the
contact information on our web site. Log onto
®
www.weber.com .
IGNITION SYSTEM- Q300
Note - The ignition system ignites the burners with a spark from the igniter electrode
inside the ignition chamber. You generate the energy for the spark by pushing the
ignition button until it clicks.
4).
3) Turn the gas on by slowly turning the cylinder valve counterclockwise. Wait 60
seconds.
WARNING: Do not lean over the open barbecue when
lighting the barbecue.
4) Select the Outside burner, push control knob in and turn to START/HI.
5a) Q300- Push the ignition button, so that it clicks. Repeat if necessary.
5b) Q320- Push the electronic ignition button several times. You will hear it spark.
6) Check that the burner is lit by looking down through the cooking grate. You should
see a flame.
WARNING: If the burner does not light, turn the burner
control knob to OFF and wait 5 minutes to let the gas clear
before you try again or try to light with a match.
7) After the Outside burner is lit you can turn on the Inside burner. The Inside burner
is ignited from the Outside burner.
TO EXTINGUISH
Push in and turn each burner control knob clockwise to the OFF position. Turn gas
supply OFF at the source.