Cooper Lighting HALO HL36A Instrucciones De Instalación página 4

Installation Instructions – HL36A and HL36SA Recessed Adjustable LED
OPTICS
1. The optic can be removed and replaced to provide a
different beam angle. To remove optic, twist counter-
clockwise. To install, insert optic and twist clockwise
(Figure 8).
2. Also available, is a single/double media holder. To install,
place the media onto the media holder. Engage snaps
at bottom of snap staircase. Twist clockwise until tight
(Figure 9).
Twist counter-clockwise
REMOVAL
Figure 8
Snap and twist
clockwise
Figure 9
4
Push up and twist clockwise
to tighten
INSTALLATION
Media holder
AIMING
This fixture allows for 365° rotational "aim" .
1. Loosen thumb screw on left of aiming bracket
(Figure 10).
2. Using the aiming bracket (Figure 10), rotate to the
appropriate position. Tighten thumb screw.
Figure 10
Thumb screw
Aiming bracket