Inverter Paralleling Operation - Westinghouse WH1000i Manual Del Propietário

OPERATION
Using Extension Cords – Westpro Power Systems
assumes no responsibility for the content within this
table. The use of this table is the responsibility of the
user only. This table is intended for reference only. The
results produced by using this table are not guaranteed
to be correct or applicable in all situations as the type
and construction of cords are highly variable. Always
check with local regulations and a licensed electrician
prior to installing or connecting an electrical appliance.
invErtEr ParallEling
oPEration
!
DANGER
Never connect the paralleling cord to
the inverters with the inverters running.
The inverters must not be running and
both the paralleling cord switches must
be off when connecting the cords.
!
WARNING
Do not attempt to parallel the
Westinghouse inverter with any other
manufacturers' inverters. Do not use
the paralleling cord for any application
other than inverter paralleling. Do not
use this cord on other manufacturers'
inverters.
24
Extension Cord Wire Gauge Size
1. Using only the Westinghouse paralleling cord (Part
No. 260041) with both cord switches set to OFF
(O), connect one male plug to one inverter and
connect the remaining plug into the other inverter.
Either of the receptacles on the inverters can be
used
Figure 14 – Paralleling Cord ON/OFF Switches
!
WARNING
Always ensure that both ends of the
paralleling cord are switched off before
connecting the inverters.
(see Figure 15).