GiBiDi PASS Serie Instrucciones Para La Instalación página 21

PASS
6-continue fitting the rack, aligning the modules one after another; to properly secure the modules, use a piece of rack
of about 150 mm to allow for tooth timing [13]. Once the last module has been secured, cut off the protruding part
with a saw.
7- when all the modules have been fitted, manually carry out various gate opening and closing manoeuvres to check
that it slides smoothly without friction;
8- lower the operator and lock the gearmotor leaving a clearance of 2 mm between the pinion and the rack [14] to
ensure that the weight of the gate does not negatively affect the gearmotor shaft.
FITTING THE LIMIT SWITCHES [16]
u
1-insert the nuts in the hexagonal seats on the magnet holder
2- insert the grub screw and nut
least 1-1.5 mm;
3- insert the adjusting screw and nut
e
4- assemble the bracket
NOTE: at this stage, it is sufficient to assemble the unit to then position it on the rack without having to tighten the
screws.
5- Position the complete limit switches on the rack in the appropriate positions.
NOTE: the limit switch marked on the cover with the letter "O" must be secured in correspondence to the gate-open
position and the one marked "C" in the gate-closed position [18].
6- To fasten the limit switch, first tighten the two screws
depending on the type of rack and then act on the grub screws
WARNING: Do not overtighten the grub screws
7- Should the limit switch not yet be sufficiently integral with the rack, you can adjust it by unscrewing the screw
WARNING: Do not exceed in this adjustment since you may deform the bracket.
ADJUSTING THE CLUTCH (PASS 800) [19]
ATTENTION: Before beginning to adjust the clutch, disconnect the power supply by turning off the main switch.
Insert the size 6 Allen wrench into the socket
Ÿ
thrust and turning it counterclockwise decreases the thrust.
If the shaft also rotates when you turn the Allen wrench, line the two sockets
Ÿ
on the flange). Then insert a screwdriver
q
in the magnet holder
y
in the hexagonal seat of the magnet holder
using the screws provided
t
so as not to deform the bracket.
w
e
and use the Allen wrench to adjust the clutch.
p
;
p
making sure that it protrudes towards the rack
r
and insert the grub screws
r
, then act on the screw
t
to securely lock the bracket to the rack.
. Remember that turning the wrench clockwise increases the
q
p
;
t
.
y
to adjust the clamp distance
up (the one on the shaft with the one
21
UK
w
by at
y
.