Parkside PTB-16 Instrucciones De Utilización Y De Seguridad página 37

• Fasten the column (6) to the baseplate
with the enclosed screws. Secure
it with the appropriate screws and
washers.
Tighten the screws with a wrench
(wrench size 12mm).
• Now install the drilling table (7) by
means of its fastener onto the column.
Clamp the assembly group in the
required position with the clamp lever
(4).
• Now mount the machine housing and
secure it with the grub screws.
• Since the spindle has been greased
generously in the factory, allow the
machine to run for approx. 15 minutes
in the lowest gear without load.
• Assemble the three lever arms of the
feed handle (3).
• Fit the chuck guard (9) on the ring (19).
Tighten the three screws.
• Fit the complete chuck guard onto the
spindle and firmly tighten the screw on
the rear side of the chuck guard (9).
• The lower part of the safety device can
be adjusted in height.
• To achieve this, loosen the wing nuts
(20), position the lower part of the
safety device as required and tighten
the wing nuts again.
• Open the drill chuck and fit it on the
cone of the drilling spindle.
• Hit the drill chuck several times lightly
with a plastic hammer, in order to
attach the drill chuck firmly to the cone
of the drilling spindle.
• Screw the vice (8) firmly to the drilling
table (7) with the vice screws (21),
washers and nuts.
• The vice can be fastened to the slotted
holes in different positions.
This allows clamping of various sized
work pieces.
The fixture (inner cone of the drill
chuck) and tapered mandrel must
be absolutely grease-free before
fitting the drill chuck on the
spindle!
Drill mounting
• Secure the drilling machine to a
workbench before starting work.
• The baseplate (5) is equipped with
drilled holes for this purpose.
• Screw the baseplate securely to the
workbench through these drilled holes
with screws.
• Use sufficiently large washers, if you
fasten the machine to a wooden plate.
This prevents the nuts pressing into the
wood, which would loosen the machine.
Only tighten the fastening screws
as much as necessary so that the
baseplate does not become
distorted or deformed. Excessive
load bears the risk of breakage.
Spindle and tapered mandrel
• All bare parts of the machine are
provided with a protective layer, which
prevents corrosion. This protective
layer can be removed easily with
environmentally safe solvents.
• Check the V-belt tension, before
connecting the machine to the mains
supply.
• Completely degrease the inner cone of
the drill chuck.
• Use environmentally safe solvents.
Proceed likewise with the tapered
mandrel of the spindle. Perfect power
transmission is only possible after
proceeding as described.
Assembly
GB/MT 35