1. Important Safety Instructions
SAVE THESE INSTRUCTIONS
This manual contains instructions and warnings that should be
followed during the installation, operation, and storage of this product.
Failure to heed these instructions and warnings may affect the product
warranty.
• The PDU provides convenient multiple outlets, but it DOES NOT provide surge or line noise
protection for connected equipment.
• The PDU is designed for indoor use only in a controlled environment away from excess moisture,
temperature extremes, conductive contaminants, dust or direct sunlight.
• Do not connect the PDU to an ungrounded outlet or to extension cords or adapters that eliminate the
connection to ground.
• The power requirement for each piece of equipment connected to the PDU must not exceed the
individual outlet's load rating.
• The total power requirement for equipment connected to the PDU must not exceed the maximum load
rating for the PDU.
• Do not drill into or attempt to open any part of the PDU housing. There are no user-serviceable parts
inside.
• Do not attempt to modify the PDU, including the input plugs and power cables.
• Do not attempt to use the PDU if any part of it becomes damaged.
• Do not attempt to mount the PDU to an insecure or unstable surface.
• Never attempt to install electrical equipment during a thunderstorm.
• Use of this equipment in life support applications where failure of this equipment can reasonably be
expected to cause the failure of the life support equipment or to significantly affect its safety or
effectiveness is not recommended. Do not use this equipment in the presence of a flammable
anesthetic mixture with air, oxygen or nitrous oxide.
2. Features
16-11-160-933685.indb 2
AC Input Power Cord (Model PDUMNH15):The cord is permanently
attached to the PDU and has a NEMA 5-15P plug.
AC Input Power Cord (Model PDUMNH20): The cord is permanently
attached to the PDU and has a NEMA L5-20P plug.
AC Input Power Cord (Model PDUMNH30): The cord is permanently
attached to the PDU and has a NEMA L5-30P plug.
2
1/4/2017 2:14:59 PM