Generator Maintenance; Battery Replacement - Firman WH02942 El Manual Del Propietario

Ocultar thumbs Ver también para WH02942:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

3. Carefully remove the carbon deposits from the
spark arrester screen with a wire brush.
4. Replace the spark arrester if it is damaged.
5. Position the spark arrester in the muffler and
attach spark arrester cover with the screws.
CAUTION
Failure to clean the spark arrester will result in
degraded engine performance.
Maintenance Valve Clearance
- Intake: 0.06 0.12 mm (0.002 - 0.004 in.)
-
- Exhaust: 0.08 - 0.14 mm (0.003 - 0.005 in.)
To be performed by knowledgable/experienced
owner or by authorized service center.

GENERATOR MAINTENANCE

Make certain that the generator is kept clean
and stored properly. Only operate the unit on
a flat, level surface in a clean, dry operating
environment. DO NOT expose the unit to
extreme conditions, excessive dust, dirt,
moisture or corrosive vapours.
CAUTION
DO NOT use a garden hose to clean the generator.
Water can enter the generator through the cooling
slots and damage the generator windings.
Use a damp cloth to clean exterior surfaces of
the generator.
Use a soft bristle brush to remove dirt and oil.
Use an air compressor (25 PSI) to clear dirt and
debris from the generator.
Inspect all air vents and cooling slots to ensure
that they are clean and unobstructed.
English

Battery Replacement

1.Unscrew the air cleaner cover by provided
screwdriver.
2. Release the battery retaining rubber belt.
3. Remove the protective cover(rubber sheath)
from battery.
4. Disconnect the black(-) cable from black(-)
terminal on the battery.
Disconnect the red(+) cable from red(+) terminal
on the battery.
Battery
Negative(-)
Terminal
5. Pull out the battery and replace with new battery:
12V sealed lead acid 5.5AH
LXWXH:90X70X100mm(3.54X2.76X3.84in)
6. Connect the red(+)battery cable to the positive
terminal of battery first and then connect the black(-)
battery cable to the negative terminal of battery.
7. Reattach the air cleaner cover.
WARNING
To avoid electric shock:
ALWAYS connect the positive (+) battery cable
(red boot) first when connecting battery cables.
Page 30
Rubber Sheath
Positive(+)
Terminal
Red Cable
Black Cable
Customer Service: 1-844-FIRMAN1

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido