Installation; Assembling A Gun Master Basic - ESAB Gun Master 400 Manual De Instrucciones

sectIon 3

3.1 ASSEMBLING A GUN MASTER BASIC

step #1
• remove gun from box and extend to full length.
• Slide nozzle off of front end of gun.
• Thread retaining head off of front end of gun.
step #2
• remove liner from package and extend to full length. feed liner into the back end of the gun using short strokes to
avoid kinking. Twist liner clockwise if necessary.
step #3
•
Seat liner retainer to end of power pin and using a 10 mm wrench, turn collet in a clockwise direction and tighten
in power pin.
step #4
•
Measure the proper liner stick-out at the front
end of the gun. cut the liner and remove any
burrs that may obstruct wire feed.
1

InstaLLatIon